搜索
NEWS CENTER
Your location:
Homepage
/
/
/
What is the installation process of Double shaft hammer mill

What is the installation process of Double shaft hammer mill

What is the installation process of Double shaft hammer mill

In the first step, we should make some preparations for the installation of Double shaft hammer mill: for example, the location of the installation, the balance of the foundation, some measurement of the distance, and so on.

Double shaft hammer mill
The second step is to make basic preparations, and carry out strict inspections on the parts of the Double shaft hammer mill again, especially in terms of accessories.
The third step is to install the lower shell. The screws are required to be tightened, and no leaks are allowed. Use the markings during processing to determine the vertical and horizontal center lines of the hammer crusher base on the Double shaft hammer mill base, and mark with the sample punch. Comparing the measurement with the basic vertical and horizontal centerline, and using the leveling measurement for the elevation.
In the fourth step of rotor installation, it is necessary to measure the longitudinal center of the rotor, the axial center, the level of the rotor ring hammer crusher, and so on. The horn setting and base setting of the Double shaft hammer mill must be taken into consideration.
The fifth step is to adjust the internal clearance. It is necessary to ensure that there is no friction and collision when the equipment is running, and try to choose a low point. Each clearance must meet the requirements of the drawings or equipment instructions.
The sixth step is to install the upper shell. When installing, pay attention to the connection of the flange. The bolt holes are facing and the bolts are tightened to avoid dust and air leakage.
The seventh step is to install the hydraulic device according to the drawings, and assemble the oil pipes on site.
The eighth step is to install the motor and other devices, such as motors, small pulleys and other devices.
The ninth step, check before operation, check whether there are sundries in each part, whether the bolts are fastened, whether there is sundries in the crushing cavity, and whether there is oil leakage at each refueling point.
The tenth step is to confirm that the clicked direction of rotation is correct, and then idling for debugging for 4 hours. Check whether the Double shaft hammer mill has noise, vibration, and the temperature rise of the motor bearing does not exceed 45°C. After the operation, check whether the bolts of each component are loose.

The above is the installation steps of Double shaft hammer mill, hope our summary can be helpful to you.

Keyword:

Return

HONGXIN MACHINERY

Call the hotline: 0086 18863070778 

 E-mail: snowsure@163.com

ADD: Yuancheng, Changshan Town, Binzhou, Shandong, CHINA 

Hotline: 0086 18863070778

E-mail: snowsure@163.com

ADD: Yuancheng, Changshan Town, Binzhou, Shandong, CHINA 

© 2021  Shandong Hongxin Machinery Co., Ltd.   All Rights Reserved.

 鲁ICP备16046072号-1   Privacy Policy   Powered by:300.cn  

terminated