09

2021

-

09

Which materials cannot be processed with Briquetting machine


The equipment pressure of the Briquetting machine is relatively high, because the materials pressed by the Briquetting machine are mostly mineral powder, wood and ore.

The equipment pressure of the Briquetting machine is relatively high, because the materials pressed by the Briquetting machine are mostly mineral powder, wood and ore. Therefore, a lot of pressure is required, and the ore has a high hardness and is difficult to form under pressure. Therefore, it is necessary to grind and crush the ore with a crusher.

Briquetting machine

Then the customer will ask the question, which materials cannot be processed by Briquetting machine? Let me introduce to you, for example, the material particles are too large, the water content of the material is too high, and so on. These cannot be processed with Briquetting machine equipment. The following is a solution to this problem. If the particles are large, you can use a grinder to grind the crushed material. What has a greater impact on the start of heavy vehicles is that the water content of the motor material of the ball press equipment is too large, and the dryer equipment can be used for drying and dehumidification.

The material or manufacturing structure design of the Briquetting machine hydraulic cylinder is unreasonable. If the low-strength steel cylinder is abused, the stability factor will decrease. If the hydraulic cylinder is used for a long time, the diameter of the hydraulic cylinder will inevitably expand and deform. Then, find out the related reasons for the expansion of the hydraulic cylinder wall of the scrap iron briquetting machine.

Briquetting machine can cut or rub the wood or pasture to be pressed, the length is less than 50mm, and the moisture content is controlled within the range of 10-25%. The material is sent to the feed port through the feed conveyor, and the main shaft rotates to drive the pressure roller to rotate, and then the pressure roller rotates. The material is forced to squeeze out of the mold hole and fall from the discharge port. Bag after cooling.
 

Briquetting,machine